Serenity - Feb 27 2006

02271.jpg
02271.jpg

Oh looking good. Using the image to mark off the locations of the vertical slats

02272.jpg
02272.jpg

Strips of styrene cut to make slats

02273.jpg
02273.jpg

To add the slats I had to cut into my part to make an area I can glue the slat into. This is a slow process as I had to make sure the cut out area was not too narrow or the part would not go in and not too wide or the fit will be sloppy

02274.jpg
02274.jpg

Glued in

02275.jpg
02275.jpg

Trimmed to side and then filed flush to the rest of the area. Not bad looking

02276.jpg
02276.jpg

Now onto the rest