SERENITY - Nov 27 2005 |
Ok now to add the little bits to the windshield frame. Start with a thin sheet of styrene. Drill a tiny hole with the drill bit |
Well lots of tiny holes since i am making quite a few of them |
Then using a punch, punch out some discs |
Here is 5 made |
It was not easy centering the hole in the punch |
4 of them are put on the windshield. I had to chop off the lower section before lining them all up with equal spacing and then gluing them on |
More punched. The 3 on the bottom are garbage. Not punched right |
More glued on |
Styrene strips for the border |
Glued on |
This will now sit and I will look at it tomorrow to see if there are any glaring errors. Then I will work the parts to make sure they are all even. Some of the dics are slightly higher then others |
Woot. I like how busy it is starting to look. It is times like this that I enjoy what I am doing. |