SERENITY - Aug 8 2005 |
First pulls from moulds. Er sorry for the crappy fuzzy pictures but they did look good on the tiny screen on my digital camera |
The rear engine section |
Hollowed inside. It took me a good hour getting the plug out. I had to put the parts in the freezer in teh hopes that the temperature difference would get it to pop out. When that failed it was into boiling water to hope the temperature difference would get it to pop out. Well it did eventually so there is a happy ending and I didn;t have to ruin any parts. |
Start of the side structures were the landing gear is housed |
The legs are finally completed. Well the basic shape is Next is puttying and sanding and a lot more of the same |
A very neat shape by itself |
I sure hope it fits the engine area |